Page: 1 
KIT LPF600 1000W LPF Unit using low-pass filter, have a SWR meter circuit
$79.0Information on KIT LPF Unit (LPF600).LPF600 using low-pass filter 5th order. It is applied in the Solid State HF amplifier DN-600. LPF600 allows you to filter the power to 1kW PEP. All of filters are for 50 ohm. Similar LPF used in amplifiers - ALS-600 - Ameritron, HL1.5Kfx - Tokyo Hy-Power. For switching filters applied powerful relays with a curr ...  More
FM Broadcast Low Pass Filter Module 9-Pole (88-108mhz) [NEW]
$81.95Visit my web site in http://www.digitaliontechnologies.com/shop FLFM600W-9L - ReV. 4.2 - FM Broadcast Low Pass Filter Module (SERIES FILTER) Frequency Range: 87.5-108 Mhz NEW, TESTED & UNUSED MODULE RETAIL PRICE: $199 YOU SAVE 5% TO 20% IN MY WEBSHOP AND PAYMENT BY PAYPAL!!! YOU READ SHIPPING, PAYMENT CONDITIONS AND WARRANTY POLICIES!!! MODULE ...  More
LPF low pass filter diplexer 1000W 1KW SSB CW HF amplifier LDMOS MOSFET RM Italy
$320.0LPF low pass filter diplexer 1000W 1KW SSB CW HF amplifier LDMOS MOSFET RM Italy Transistor amplifierss are inherently rich in harmonics. This is because of the non-linear junction that all transistors have. This design passes the lower desired signal to the antenna port using a low-pass filter, and sends the higher frequency by-products via a high ...  More
LPF diplexer 300W SSB/CW HF amplifier low pass filter MOSFET LDMOS RM Italy
$150.0Transistor amps are inherently rich in harmonics. This is because of the non-linear junction that all transistors have. This design passes the lower desired signal to the antenna port using a low-pass filter, and sends the higher frequency by-products via a high-pass filter into a termination. The diplexer consists of 6 relay-switched units and cov ...  More
1KW BLF188XR LDMOS rugged AMPLIFIER with HIGH POWER LOW PASS FILTERS!!
$1750.0BLF188XRS 1 KW LDMOS-FET LINEAR AMPLIFIER EXTREMLY RUGGED STATE OF THE ART !!! with HIGH POWER BAND PASS FILTERS This ,BLF188XRS PnP amplifier ,was created to enable the use of the latest LDMOS-FET's device This amp is using the latest state of the art XR device from NXP (former PHILIPS) The board used is double sided plated G-10 board 3oz. copper ...  More
   Page: 1 

Copyright 2003 - 2015 hamradiogears.com (16568). All rights reserved.